« 6TH POPE Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Israeli compassion for Palestinian in trouble 

By: Beldin in 6TH POPE | Recommend this post (2)
Tue, 14 May 24 5:31 AM | 19 view(s)
Boardmark this board | 6th Edition Pope Board
Msg. 53155 of 58625
Jump:
Jump to board:
Jump to msg. #

Hind Khoudary is a Palestinian "journalist" and activist ... 

Uploaded Image

Earlier today, Hind posted a very concerning tweet ... 

Hind Khoudary (@Hind_Gaza) ~ I am about to explode.
2:08 AM · May 13, 2024

Fortunately, a former member of the Israel Defense Forces saw her plea for help and immediately offered life-saving assistance ... 

Cheryl E (@CherylWroteIt) ~ Right, I can help you here Hind, but I need you to listen to me very carefully.

Firstly, find a pair of wire cutters, and a flat screwdriver, ideally with a small head. Take them and go to a place where you are far away from anybody… as a precaution of course.

Now very very slowly, look down at the belt and you should see 5 thin wires, each with a different color. Gently run your fingers along the two wires that run from the explosives to the trigger mechanism which I suspect will be that little black box with a flat red button on it that you’re holding. I would assume the wires are yellow and white because you guys haven’t yet mastered how to use colors properly. Now focus on just the yellow wire.

Now don’t cut the wire just yet. First slide the wire in the explosives a little to the left and you’ll see the small screw and nut holding it down. Take the screwdriver and very gently remove the cap off the screw to reveal its head.

Now, even slower, place the tip of the screwdriver into the slot of the small screw, and turn it until the wire is loose but DO NOT pull the wire out.

Once the screw is loose, find some chewing gum and chew like the your life depends on it, then bite a small piece of chewed gum off and place it into the hole where the wires are in until it’s completely filled but with the wires still in place. Now take the rest of the gum and place it on top of the screw like a makeshift cap and gently press down so that it stays fast. The wires should not be removed still.

Leave this for 10 minutes, then take the wire cutters and ever so slowly, cut the green wire first. Then slowly cut the brown wire.

Now, if I’m right, the gum will be dry and you need to slowly cut the yellow wire close to the trigger, not the belt.

If this works, the trigger will be disarmed and the gum will keep the wire in the belt fastened and you can slowly take the belt off and place it down gently.

If I’m wrong, and the yellow wire is just a dummy wire, and the trigger is the white one, well then I suppose it was nice knowing you.

Unfortunately ... something went wrong ... 

Uploaded Image

Uploaded Image

Uploaded Image

Palestinian Journalist 'Ready to Explode' - The Responses Are Dynamite
http://twitchy.com/gordon-k/2024/05/13/palestinian-journalist-ready-to-explode-the-responses-are-dynamite-n2396190




Avatar

The essential American soul is hard, isolate, stoic, and a killer. It has never yet melted. ~ D.H. Lawrence




» You can also:
« 6TH POPE Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next